American Audio Q-FXPRO Betriebsanweisung PDF herunterladen (Seite 8)

Q-FXPRO CONTROLS AND FUNCTIONS

©American Audio® - www.americanaudio.us - Q-FXPRO Instruction Manual Page 8

1. MICROPHONE 1 - This combo jack will accept a standard 1/4 plug or XLR 3-pin balanced male

plug. The volume output level for this microphone will be controlled by its own respective CHANNEL

KNOB (29). Note: We recommend that you use a 500-600ohm microphone for the best sound

quality.

2. SOURCE SELECTOR SWITCH - These switches are used to select the input source assigned to

each channel. Each channel may only be assigned one input source at a time. This switch must be in

the “phono” position for turntable operation.

3. CHANNEL GAIN CONTROL - This adjustment is used to adjust the audio source signal input gain

for a channel. Never use the gain control to adjust a channels output volume. Setting the gain level

properly will ensure a clean output signal. An improper gain level adjustment will send a distorted

signal throughout the entire audio line which may damage speakers and amplifiers. To properly set a

channels gain level control:

1. Be sure the MASTER VOLUME CONTROL (

7) is set to level 8.

2. Set the CHANNEL FADER (

6) to level 8.

3. Begin playback on an audio source connected to the channel you are adjusting.

4. Use the Gain Control to adjust an average output volume of +4 dB

5. Repeat this step for all channels

4. CHANNEL TREBLE CONTROL - This knob is used to adjust the treble levels of a channel

allowing for a maximum treble gain of 12dB or maximum decrease of -30dB. Turning the knob in

a counter-clockwise direction will decrease the amount of treble applied to a channel signal, turn-

ing the knob in a clockwise direction will increase the amount of treble applied to a channel signal.

FRONT PANEL

98765432

1922 21 20 18 17 16

2425

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 21 22

Keine Kommentare

American Audio Q-FXPRO Betriebsanweisung Seite 8