5. CHANNEL MIDRANGE CONTROL - This knob is used to adjust the midrange levels of a channel
allowing for a maximum midrange gain of 12dB or maximum decrease of -30dB. Turning the knob in a
counter-clockwise direction will decrease the amount of midrange applied to a channel signal, turning
the knob in a clockwise direction will increase the amount of midrange applied to a channel signal.
6. CHANNEL VOLUME FADER - These faders are used to control the output signal of any source
assigned to its particular channel. However, master volume is controlled by the MASTER VOLUME
CONTROL (7).
7. MASTER VOLUME CONTROL - This slider is used to control the master output level (main volume).
To avoid distorted output try to maintain an average output signal level no greater than +4 dB. (see
Channel Gain 2) To avoid speaker damage that may be caused by excessive volume, be sure this
slider is always set to zero (completely down) before turning the unit on.
8. MASTER OUTPUT MONO/STEREO SWITCH - This switches the Master Output signal between
stereo and mono.
9. MASTER OUTPUT BALANCE CONTROL - This knob is used to control the pan, adjust how much
of the signal is sent to the left and right output level. For true stereo imaging, maintain the knob in the
12 o’ clock position.
10. MASTER VOLUME LEVEL INDICATORS - The dual MASTER LEVEL LED indicator
s are used
to detail the master fader output level. The meters will detail the output level of both the left and right
channels.
11. MAIN POWER SWITCH - This is the main power ON/OFF button. Before main power is applied,
be sure you have made all connections to the mixer. Also be sure your amplifier(s) is(are) tuned off.
Remember to avoid damaging pops to the speakers, the mixer is turned on first and turned off las
t.
12. DSP EFFECTS (DIGITAL SIGNAL PROCESSING)
TIME ARRAY KNOB (PARAMETER X) - This knob is used to adjust the parameter time value.
DEPTH FEEDBACK KNOB (PARAMETER Y) - This knob is used to adjust the parameter ratio
value.
INPUT SELECT - This knob is used to select a channel in which to apply effects.
EFFECTS SELECTOR KNOB - This knob is used to select a desired effect. The effects have
two adjustable parameters, Time Array and Depth Feedback. Effects are listed below;
ECHO - When the ECHO effect is selected it will add an echo to your output signal.
AUTO PAN -
When the PAN effect is selected the effect will automatically pan the output from
the left channel to the right channel.
TRANS - When the TRANS effect is selected it will simulate a real-time mixer transformer
effect.
MANUAL & AUTO FILTER - When the FILTER effect is selected it will tweak the original sound
to add different tonal definition.
FLANGER - When the FLANGER effect is selected distorts the output signal and creates an
effect similar to frequencies phasing in and out of each other.
PITCH SHIFT - When the PITCH SHIFT effect is selected it can increase or decrease the play-
ing speed. Using the BEAT SYNC button you can change the pitch percentange between
- 100%, -50%, 0%, +50%, and +100%.
Q-FXPRO CONTROLS AND FUNCTIONS cont.
©American Audio® - www.americanaudio.us - Q-FXPRO Instruction Manual Page 9
(26 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern