American Audio COMMANDER PLUS - REV 4-5 Bedienungsanleitung PDF herunterladen (Seite 6)

CONNECTIONS

Power

HEX requires 9VDC at 100mA to a 5.5x2.1mm center negative barrel connector.

Since this is the same as most pedal effects, you can use any 9VDC output from

a Voodoo Lab Pedal Power. Alternately, most 9V power supplies intended for

battery operated pedals are also acceptable.

If you are using a Voodoo Lab foot controller, such as Ground Control Pro or

Commander, it can be phantom powered from HEX. Phantom power is provided

over pins 1 and 3 of HEX’s MIDI IN. Make sure to use a MIDI cable with all 5 pins

wired. These are often labeled “5-pin active.”

Important: When using phantom power, you must provide enough current to

operate both HEX (100mA) and your foot controller. For example, if your foot

controller needs 500mA, then your power supply must be capable of providing at

least 600mA (500+100) to operate both.

MIDI

HEX will respond to MIDI commands to recall preset combinations of all 6 loops,

or turn individual loops on and off. You can use any device capable of sending

MIDI program change or control change messages.

Connect a standard 5-pin MIDI cable from your controller’s MIDI out to HEX’s

MIDI IN. If you have additional MIDI devices, connect another MIDI cable from

HEX’s MIDI OUT to the MIDI in of your next device.

Audio Loops

HEX has 6 true bypass audio loops. Loop 1 is independent and completely

isolated from the others. Loops 2-6 are internally wired in series.

All connections are 1/4” mono for standard guitar audio patch cables.

For each loop, connect a patch cable from the send (S) to your effect’s input, and

from your effect’s output to the return (R).

You are free to patch loop 1 and loops 2-6 into your rig to suit your needs. Most

common would be from your guitar to loop 1 IN, then loop 1 OUT to loop 2 IN,

and finally from loop 6 OUT into your amplifier.

1 2 3 4 5 6 7 8 9 10 11 12

Keine Kommentare

American Audio COMMANDER PLUS - REV 4-5 Bedienungsanleitung Seite 6