American Audio COMMANDER PLUS - REV 4-5 Bedienungsanleitung PDF herunterladen (Seite 8)

MCP 1000 • Installation

Installation

MCP 1000 • Installation

2-2 2-3

Mounting instructions

Follow these steps to rack mount the MCP 1000:

1. Attach the mounting brackets to the unit using eight of the

machine screws supplied with the mounting kit.

2. Insert the unit into the rack and align the holes in the

mounting brackets with the holes in the rack. Use four of

the supplied machine screws to attach the brackets to the

rack.

Rack Mounting

Bracket

#8 Screws

(4 Places

Each Side)

Rack mounting the MCP 1000

Rear Panel Connections

There are many ways to connect the MCP 1000 to other

products. However, there are two general applications:

one using RS-232, and the other using the comm-link port.

In some applications, both of these connectors are used.

Chapter 3, "Operations," includes illustrated examples of several

applications.

COMM - LINK PORT

RS-232

1.5A MAX.

100-240V 50/60Hz

HOSTSWITCHER

CBA EDCBA

2 3 5

MCP 1000 rear panel connectors

Mounting the MCP 1000

The MCP is 1U high by 17.5" wide by 5" deep. It can be placed

on a table or other furniture, or it can be mounted in a rack

using mounting brackets (“rack ears”).

Tabletop use

Four self-adhesive rubber feet are included with the MCP 1000.

For tabletop use, attach one foot to each corner of the bottom

side of the unit and place the MCP in the desired location.

Rack mounting

The MCP can optionally be mounted in a rack with the supplied

MBD 149 rack mounting kit (part #70-077-03).

UL requirements

The following Underwriters Laboratories (UL) requirements

pertain to the installation of the MCP 1000 into or onto a rack.

1. Elevated operating ambient — If the equipment is

installed in a closed or multi-unit rack assembly, the

operating ambient temperature of the rack environment

may be greater than room ambient. Therefore, consider

installing the equipment in an environment compatible

with the maximum ambient temperature (Tma) speciﬁ ed

by the manufacturer.

2. Reduced air ﬂ ow — Installation of the equipment in a rack

should be such that the amount of air ﬂ ow required for

safe operation of the equipment is not compromised.

3. Mechanical loading — Mounting of the equipment in

the rack should be such that a hazardous condition is not

achieved due to uneven mechanical loading.

4. Circuit overloading — Consideration should be given to

the connection of the equipment to the supply circuit and

the effect that overloading of the circuits might have on

over current protection and supply wiring. Appropriate

consideration of equipment nameplate ratings should be

used when addressing this concern.

5. Reliable earthing (grounding) — Reliable earthing

of rack-mounted equipment should be maintained.

Particular attention should be given to supply connections

other than direct connections to the branch circuit (such as

the use of power strips).

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 20 21

Kommentare zu diesen Handbüchern

Keine Kommentare

American Audio COMMANDER PLUS - REV 4-5 Bedienungsanleitung Seite 8

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Audiomischer American Audio COMMANDER PLUS - REV 4-5