American Audio COMMANDER PLUS - REV 4-5 Bedienungsanleitung PDF herunterladen (Seite 9)

MCP 1000 • Installation

Installation, cont’d

2-4

MCP 1000 • Installation

2-5

RS-232 connectors (master)

Power connector — Plug the provided power cord into this

connector to connect the MCP to a 100-250 VAC, 50/60 Hz

power source.

Switcher — Use this 9-pin connector for communication

between the MCP 1000 and a comm port on the switcher that

will be controlled by the MCP 1000.

Host — Use this 9-pin connector for communication between

the MCP 1000 and a comm port on the RS-232 controlling device

or a computer with Extron’s control software for Windows

installed.

CAUTION

Do not use delay or pause characters (commands

that delay execution of the next SIS command) in

RS-232 commands. Use contiguous SIS characters.

The RS-232 connector uses the following pin assignments:

Pin Description

Not used

Transmit data

Receive data

Not used

Signal ground

Not used

The protocol is 9600 baud, 8-bit, 1 stop bit, no parity, and no

ﬂ ow control.

The illustration on the next page shows a host controller and a

switcher connected to the RS-232 ports on the MCP 1000.

MCP 1000

MENU NEXT

MCP 1000 (master)

RS-232

AUD.VID.

SWITCHER

AUD.VID.

SWITCHER

Host

Control

Switcher to be controlled

MCP 1000, host controller, and switcher

Comm-link connectors (master or slave)

and

Comm-link panel connectors — Connect a matrix

switcher or another (master or slave) MCP to these 5-pole, 5 mm

male connectors. The MCP 1000 includes two female connectors

for making cables.

Although comm-link connections can be used in a master

application, the typical application is a large matrix system, such

as a Matrix 6400. This can include multiple MCP 1000 units,

as well as MKP 1000 units, intermixed. See the application

examples illustrated in chapter 3, "Operations."

Making cables

Choose a cable such as AMX/Panja’s Axlink, Crestron’s Cresnet,

or Extron’s Plenum Comm-Link cable. The wire speciﬁ cations

for comm-link cable are on page 2-5. After running the cables,

follow the procedure below to install the connectors.

The appropriate connectors are shipped with each device:

MCP 1000 — Use 5 mm connectors (Extron part number

10-163-13).

MKP 1000 — Use 3.5 mm connectors (Extron part number

10-319-10).

Matrix 3200/6400 master BME — Use 5 mm connectors (Extron

part number 10-163-13).

CAUTION

Do not connect both a Matrix 3200/6400 BME

and an MCP 1000M (master) unit on the same

comm-link connection. Also, do not connect more

than one master on the same comm-link connection.

Both of theses units supply voltage to the comm-

link ports on pins A and B. Connect these pins

to only one power source. This does not apply to

MCP 1000S (slave) units.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 20 21

Kommentare zu diesen Handbüchern

Keine Kommentare

American Audio COMMANDER PLUS - REV 4-5 Bedienungsanleitung Seite 9

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Audiomischer American Audio COMMANDER PLUS - REV 4-5