SE R IA L N O:
MODEL NO : Q-2422
POWER SOURCE
:
115/230V~ 50/60Hz 13W
MKII
MADE IN CHINA
MIN MAX
TRIM OUTPUT
AB
BO OT H
©American Audio® - www.americanaudio.us - Q-2422 MKII Limited User Instructions page 12
Q-2422 MKII LIMITED™ REAR PANEL - CONTROLS AND FUNCTIONS
27. GND (GROUND TERMINAL) - Be sure to connect turntable ground leads to either or both of the
two available ground terminals. This will reduce the humming and popping noises associated with
magnetic phono cartridges.
28. MICROPHONE 2 CONNECTOR - This jack is used to a connect a microphone to the mixer.
Connect you microphone via this 1/4 inch (6.3mm) jack. The volume output level for this
microphone
will be controlled by its own respective CHANNEL KNOB (24).
29. CHANNEL LINE LEVEL SELECTOR SWITCHES - These switches are used to change the volt
-
age line levels of there respected Phono / Aux RCA inputs jacks. When connecting turntables with
magnetic cartridges to these jacks be sure the corresponding switch is in the “PHONO” position,
and when using line level input devices be sure this switch is in the “AUX” position. Always be sure
main power is shut off before change the position of the Line Level Selector Switch.
30. CHANNEL 1: PHONO 1/AUX 1 INPUT - The type of input must directly reflect the selected mode
of the LINE LEVEL SELECTOR SWITCH (29). Turntables equipped with MM pickup cartridge (All DJ
turntable use MM pick-up cartridges) may be connected to these jacks as long as the LINE LEVEL
SELECTOR SWITCH (29) is in the “PHONO 1” position. CD players, Tape Decks and other line level
instruments may only be connected to these jacks as long as the LINE LEVEL SELECTOR SWITCH
(29) is in the “AUX 1” position. Never connect line level instruments (CD players, tape decks, etc.)
to these jacks when the LINE LEVEL SELECTOR SWITCH (29) is in the “PHONO 1” position, THIS
MAY SERIOUSLY DAMAGE YOUR MIXER! The red colored RCA jack represents the right channel
input and the white represents the left channel input. Input volume will be controlled by the channel
one fader. The channel SOURCE SELECTOR SWITCH (3) must be in the "Phono 1/Aux 1" position,
to monitor any source connected to these jacks.
CHANNEL 1: LINE 1 INPUT JACKS - DO NOT CONNECT TURNTABLES TO THESE JACKS!
CD players, Tape Decks and other line level instruments may be connected to these jacks. The red
colored RCA jack represents the right channel input and the white represents the left channel input.
Input volume will be controlled by channel one fader. The channel SOURCE SELECTOR SWITCH (3)
must be in the "Line 1" position, to monitor any source connected to these jacks.
31. CHANNEL 2: PHONO 2/AUX 2 INPUT - The type of input must directly reflect the selected mode
of the
LINE LEVEL SELECTOR SWITCH (29). Turntables equipped with MM pickup cartridge (All DJ
turntable use MM pick-up cartridges) may be connected to these jacks as long as the LINE LEVEL
SELECTOR SWITCH (29) is in the “PHONO 2” position. CD players, Tape Decks and other line level
instruments may only be connected to these jacks as long as the LINE LEVEL SELECTOR SWITCH
(29) is in the “AUX 2” position. Never connect line level instruments (CD players, tape decks, etc.)
to these jacks when the LINE LEVEL SELECTOR SWITCH (29) is in the “PHONO 2” position, THIS
27
31 29 30 29 2840 39 38 37 36 3534 33 32
(35 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern