American Audio ELS15A Spezifikationen Seite 7

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 14
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 6
©American Audio® - www.AmericanAudio.us - ELS15A - Instruction Manual Page 7
E
LS15A Rear Panel Controls and Features
Rear Panel:
1. OUTPUT VOLUME - This knob is used to regulate the output volume. Turning the knob in a
clockwise direction will increase the volume level.
2. TREBLE CONTROL – This knob is used to adjust the amount treble applied to the output sig-
nal. The maximum amount of treble gain is +12dB and the maximum amount of treble decrease
is -12dB. Turning the knob in a counter-clockwise direction will decrease the amount of treble
applied to a channel signal, turning the knob in a clockwise direction will increase the amount
of treble applied to a channel signal.
3. BASS CONTROL – This knob is used to adjust the amount bass applied to the output signal.
The maximum amount of bass gain is +12dB and the maximum amount of bass decrease is
-12dB. Turning the knob in a counter-clockwise direction will decrease the amount of bass ap-
plied to a channel signal, turning the knob in a clockwise direction will increase the amount of
bass applied to a channel signal.
4. XLR PARALLEL OUTPUT JACK – This jack is used to send the incoming line level and mic
signal from either of the Line Level Inputs Jacks to another ELS15A or other line level input jack
such as a mixer or power amp.
5. BALANCED XLR/RCA COMBO LINE INPUT – This connection is designed to accept a bal-
anced line input signal from a mixer or other line level device with a balanced output jack. Use a
balanced cable when the signal cable length exceeds 15 feet, this will reduce excessive signal
loss. Be sure to connect only line level input devices such as mixers and tape machines to this
jack.
6. MAIN POWER INLET – This connector is used to supply main power to the unit via the
included detachable power cord. The power connection uses an I.E.C. type connector, use
only the supplied polarized AC power cord. Use only a power cord that matches this type
of connection. Be sure to only connect this unit to a power outlet that matches the printed
power label on the unit. Never use a power when the ground prong has been removed or
broken off. The ground prong is used to reduce the risk of electrical shock in case of an elec-
trical short. This cord is designed to t in one direction only. Do not attempt to force a cord
if it does not t, be sure the cord is being inserted properly.
FUSE HOLDER – This housing stores the 3.15 amp GMA protective fuse. Always replace with
the exact same type fuse, unless otherwise instructed, by an authorized American Audio®
service technician. Replacing with any other type of fuse than that of the recommended fuse
will void your unit warranty.
7. MAIN POWER SWITCH – This is the main power ON/OFF button. Before main power is applied,
be sure you have made all connections to the speaker. Remember to avoid damaging pops to
the speakers, the mixer is turned on rst and turned off last.
8. MIC XLR/1/4” INPUT – This jack will accept a XLR or 1/4” plug. The volume output level for
this microphone will be controlled by the MIC Volume knob (9).
9. MIC LEVEL - This knob is used to regulate the microphone output volume. Turning the knob in
a clockwise direction will increase the volume level.
10. LINE LEVEL INPUT VOLUME – This knob is used to regulate the output signal of the line level
source connected to the Line Level Input Jack (5).
Seitenansicht 6
1 2 3 4 5 6 7 8 9 10 11 12 13 14

Kommentare zu diesen Handbüchern

Keine Kommentare