Inputs and Outputs lRear Panel) Cont.
(16) GND (GROUND TERMINALS) - Connect the ground lead of the turntables with this terminal. This helps to reduce
humming and popping noises.
(17), (18) LINE / PHONO / AUX INPUT JACKS - Input jack for CH-1, and CH-2. Connect turntables equipped with MM
pickup cartridge to PHONO inputs. CD players or Tape Decks should be connected to LINE input. Line level musical
instruments with stereo outputs such as Rhythm Machines or Samplers should also be connected to LINE inputs.
CHANNEL 1 (17) features left and right RCA inputs for LINE 1 and PHONO 1 / AUX 1. CHANNEL 2 (18) features left
and right RCA inputs for LINE 2 and PHONO 2 / AUX 2. Other inputs (ie. CD players) may also be used in the
PHONO/AUX RCA jacks(17, 18) when the PHONO/AUX SELECTOR SWITCH (19) is set to AUX.
(19) PHONO / AUX SELECTOR SWITCH - Changes phono to an extra line; allows the DJ to use a CD player or other
input device in the same line as the phono line. When using a turntable select PHONO, and when using other input
devices select AUX. PHONO/AUX lines can be used with LINES 1 and 2. The PHONO /AUX SELECTOR SWITCH
gives the DJ the possibilities of 4 inputs lines (ie. 4 lines CD, tape etc.; or 2 lines CD, tape etc. and 2 phono lines).
(20) REC OUT - Connect to your record unit. The REC OUT level is not influenced by the master control (13).
(21) MASTER OUT - Parallel output of P.A. output. Connect with the input of a power amplifier.
(22) MIC JACK - Connect your microphone with 1/4 inch (6.3mm) jack plug here. The signals may be controlled by
the DJ MIC CONTROL KNOB (15). BASS & TREBLE can be adjusted by the DJ MIC BASS CONTROL KNOB (15) and
the DJ MIC TREBLE CONTROL KNOB (15).
(23) FUSE - Fuseholder. Only replace the fuse when the device is disconnected from main power supply. Only replace
with fuses of the same power and rating.
(24) AC CONNECTION - Standard IEC plug with detachable AC power cord.
(25) AC VOLTAGE SELECTOR - Select between 115V/5OHz or 230V/6OHz. Make sure that the selector is set to the
proper voltage you are using.
Replacing the Crossfader
• Disconnect from main power supply
• Remove the fader knob.
• Remove the two outer screws.
• Take the fader out and unplug the connection cable.
• Connect the new fader and replace back into mixer.
Changing the Transformer Switch
• Disconnect from main power supply.
• Unscrew 2 larger Philips screws (see arrow on diagram at the right).
• Move switch to desired position.
• Reinstall screws.
XDM-2221 “SKILZ” User Instructions page 7
➔
➔
(18 Seiten)
(10 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern