Si473x-B20
Rev. 0.5 7
Figure 1. Reset Timing Parameters for Busmode Select
Table 4. Reset Timing Characteristics
1,2
(V
DD
= 2.7 to 5.5 V, V
IO
= 1.5 to 3.6 V, T
A
= –20 to 85 °C)
Parameter Symbol Min Typ Max Unit
RST
Pulse Width and GPO1, GPO2/INT Setup to RST
t
SRST
100 — — µs
GPO1, GPO2/INT
Hold from RST t
HRST
30 — — ns
Important Notes:
1. When selecting 2-wire mode, the user must ensure that a 2-wire start condition (falling edge of SDIO while SCLK is
high) does not occur within 300 ns before the rising edge of RST.
2. When selecting 2-wire mode, the user must ensure that SCLK is high during the rising edge of RST
, and stays high until
after the first start condition.
3. If GPO1 and GPO2 are actively driven by the user, then minimum t
SRST
is only 30 ns. If GPO1 or GPO2 is hi-Z, then
minimum t
SRST
is 100 µs to provide time for on-chip 1 M devices (active while RST is low) to pull GPO1 high and
GPO2 low.
70%
30%
GPO1
70%
30%
GPO2/
INT
70%
30%
t
SRST
RST
t
HRST
Kommentare zu diesen Handbüchern