This switch controls the units main power.
2. Channel 1 Limiter Switch (V2000 & V3000 Only) -
to activate the channels built-in limiter. The limiter reduces the average
output level when the signal begins to distort, this process is designed
to reduce distortion and protect the speakers. See limiter page 12.
3. Channel 1 Clip Indicator -
This red LED will begin to ash when
channel one begins to overload (clip). At this point channel one will be-
gin to distort. Under heavy clipping activity lower the channel one gain
control to reduce the risk of damage to your speakers and ampli er. This
LED may glow when the unit has been turned off, this is normal.
4. Channel 1 Protect Indicator -
The red Protect LED will begin to
glow when the channel goes into protect mode. When the channel goes
into protect mode all output for that channel will turn off. This is to pro-
tect any speakers connected to the channel.
This blue LED will glow when main power is ap-
plied to the unit. This light may continue to glow brie y after main power
has been turned off, this is normal.
6. Channel 2 Protect Indicator -
The red Protect LED will begin to
glow when the channel goes into protect mode. When the channel goes
into protect mode all output for that channel will turn off. This is to pro-
tect any speakers connected to the channel.
7. Channel 2 Clip Indicator -
This red LED will begin to ash when
channel two begins to overload (clip). At this point channel one will be-
gin to distort. Under heavy clipping activity lower the channel one gain
control to reduce the risk of damage to your speakers and ampli er. This
LED may glow when the unit has been turned off, this is normal.
8. Channel 2 Limiter Switch (V2000 & V3000 Only) -
to activate the channels built-in limiter. The limiter reduces the average
output level when the signal begins to distort, this process is designed
to reduce distortion and protect the speakers. See limiter page 12.
These vents are used for proper cooling. Never
block these vents and keep them clean at all times.
10. Channel 1 Gain Control -
This rotary knob is used to control the
output signal of channel one. Turning the knob in a clockwise direction
will increase signal output.
11. Channel 1 Signal Indicators -
These green and yellow LED’s will
glow according to the average signal output.
12. Channel 2 Signal Indicators -
These green and yellow LED’s will
glow according to the average signal output.
13. Channel 2 Gain Control -
This rotary knob is used to control the
output signal of channel two. Turning the knob in a clockwise direction
will increase signal output.
- www.americandj.com - Vplus - www.americandj.com - V
Series Amplifiers Power Amplifier User Manual Page 5
(16 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern