American Audio DTI 1.8 Spezifikationen PDF herunterladen (Seite 14)

14. START/STOP Button - This over sized push button controls platter

motion. When the unit is turned on, the platter will

not automatically begin to spin. Pressing the button

once will engage the high torque motor and spin the

platter, pressing the button again will stop the platter.

15. Voltage Selector - Because power supplies vary from location to loca-

tion a voltage selector switch has been incorporated

in the unit's design. This switch can select a volt-

age input of 120v or 220v to accommodate the two

major power source. Always be sure to disconnect

the power plug before changing the voltage.

16. Power Button - This button turns the turntable power on and off.

17. Power Connector - This is the main power connection. Only use the

supplied power cord. Use of any other power cord

may result in sever damage to the unit. Be sure the

local power matches the unit’s required power.

18. Ground Connector - This ground connection is designed to reduce the

humming and popping noises associated with mag-

netic phono cartridges. Be sure to connect the turn-

table ground lead to any available ground terminal

on the same mixer the input signal leads are

connected to.

19. RCA Output Jacks - These jacks are used to send a low voltage "phono"

level output signal to a mixers "phono" input jacks.

Turntables should only be connected to “Phono”

inputs on a mixer. The red colored RCA jack re-

presents the right channel input and the white rep

resents the left channel input.

CONTROLS AND FUNCTIONS

*Just only dual voltage model has this switch.

1519 18 17 16

REAR PANEL CONNECTIONS AND FUNCTIONS

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

Keine Kommentare

American Audio DTI 1.8 Spezifikationen Seite 14