American Audio POWER DRIVE 22 Bedienungsanleitung PDF herunterladen (Seite 29)

©American Audio® - www.americanaudio.eu VMS2™ User Manual Page 29

15. EQ MODES

The EQ for the USB audio can work in

two different modes, Pre & Post EQ.

These EQ modes work in the 4 out

interface mode that is described in

chapter 13.1 4 Out Mode.

In Pre EQ, the USB audio signal is

affected by the VMS2™ EQ. Pre EQ is

the default EQ. In Pre EQ mode the

ASIO Driver will list the VMS2™ device

number; the first number in the

sequence will be a "0" (See picture).

Note: Beware that mapping the MIDI on the EQ knobs in this mode will cause your audio to

process the EQ from the software and VMS2™ EQ.

Post EQ is for users who prefer using

the EQ from their software. To toggle

the Post EQ mode on and off, do as

follows:

Before powering up the VMS2™,

press and hold the Forward

Search Button (8) on deck 2 and

then power on the unit.

Release the button - your

computer may reinstall the

VMS2™ as a new device, please

allow 10-20 seconds for the

change to take place.

Confirm the EQ change by checking the ASIO Driver configuration. The first number in the

sequence will be a "1" in this mode (See picture).

Note: Make sure you are using software where you can map the MIDI from the EQ and that

the EQ has been mapped when using this mode.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 39 40

Keine Kommentare

American Audio POWER DRIVE 22 Bedienungsanleitung Seite 29