American Audio TTD-2400 USB Bedienungsanleitung PDF herunterladen (Seite 13)

Ame

ican

Audio

TTD-2400 USB Instruction Manual Page 13

12. PITCH ADJUST SLIDER - This slider is used to adjust the playback pitch

percentage (platter speed). Use this slider to match the BPM’s of this unit to that

of another music source.

13. TONEARM LEVER - This lever is used to safely elevates the tone arm above

a record surface without endangering a records surface.

14. TONEARM CLAMP AND REST - Use this rest to safely hold the tonearm in

position during non use and transportation.

15. ANTI-SKATE CONTROL - The anti-skate applies inward force to the

tonearm to prevent outward skipping across the record due to the centrifugal

force cause by platter rotation. The antiskate value should be equally to that of

the stylus counterweight pressure (see counterweight 16).

16. COUNTERWEIGHT - The counterweight adjustment applies the proper

downward pressure on the stylus.

17. EXTRA STYLUS HOLDER - This cut out has been designed to safely store

an extra stylus headshell.

18. PRESSURE SCALE - The pressure scale has to be seen by the DJ.

19. PLATTER - This platter connects directly to the center spindle (3). The platter

and center spindle (3) holds a vinyl record perfectly center. The platter also spins

the record at a consistent speed.

20. USB CONNECTOR: After connecting the Turntable to the computer via USB,

you can record your vinyl to your harddisk using the included Audacity software.

21. PHONO /LINE SWITCH:This switch is used to change the mode of PHONO

OUTPUT or LINE OUTPUT.

22. GROUND CONNECTOR - This ground connection is designed to reduce the

humming and popping noises associated with magnetic phono cartridges. Be

sure to connect the turntable ground lead to any available ground terminal on

the same mixer the input signal leads are connected to.

23. RCA OUTPUT JACKS - The output is switchable PHONE/LINE output. For

example:These jacks are used to

send a low voltage

"phono" level output signal

to a mixers "phono" input

jacks. Turntables should

only be connected to “Phono”

inputs on a mixer. Th e red colored RCA jack

represents the right channel input

and the white represents the left channel

input.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 33 34

Keine Kommentare

American Audio TTD-2400 USB Bedienungsanleitung Seite 13