©American Audio® - www.AmericanAudio.us - XSP Series - Instruction Manual Page 10
X
SP Series Controls and Features
9. 1/4” LINE OUTPUT JACK – This jack is used to send the incoming line level signal from
either of the Line Level Inputs Jacks to another XSP-10P or other powered speaker.
10. BASS CONTROL – This knob is used to regulate the amount bass applied to the output
signal. The maximum amount of bass gain is +12dB and the maximum amount of bass
decrease is -12dB. Turning the knob in a counter-clockwise direction will decrease the
amount of bass applied to a channel signal, turning the knob in a clockwise direction will
increase the amount of bass applied to a channel signal.
11. XLR LINE OUTPUT – Using a XLR cable, use this port to daisy chain from your XSP-10P to
another XSP-10P or other powered speaker.
12. POWER INDICATOR LED - LED lights up to indicate the speaker is on.
13. CLIP LED - If this LED is lit it means your signal is clipping. To stop the signal from clipping
lower the volume to the point where the LED is blinking along with the bass beat.
14. AC VOLTAGE SELECTOR - This switch is used to change the operating voltage. Operat-
ing voltage can be toggled between 115v or 230v/50~60Hz. Be sure the selector is set to
the proper voltage for your area before attempting to operate the unit. Always be sure
main power is shut off before change the position of the Voltage Selector Switch.
15. MAIN POWER INLET – This connector is used to supply main power to the unit via the in-
cluded detachable power cord. The power connection uses an I.E.C. type connector, use
only a power cord that matches this type of connection. Be sure to only connect this unit to
a power outlet that matches the printed power label on the unit. Never use a power when the
ground prong has been removed or broken off. The ground prong is used to reduce the risk
of electrical shock in case of an electrical short. This cord is designed to t in one direction
only. Do not attempt to force a cord if it does not t, be sure the cord is being inserted prop-
erly.
16. FUSE HOLDER – This housing stores the 3.15 amp GMA protective fuse. Always replace
with the exact same type fuse, unless otherwise instructed, by an authorized American
Audio® service technician. Replacing with any other type of fuse than that of the recom-
mended fuse will void your unit warranty.
17. MAIN POWER SWITCH – This is the main power ON/OFF button. A green LED directly above
the power switch will glow indicating power is ON. Before main power is applied, be sure you
have made all connections to the speaker. Remember to avoid damaging pops to the speak-
ers, the mixer is turned on rst and turned off last. Always turn down the INPUT VOLUME (3)
before switching off the speaker. Never turn off the speaker when there is a running sig-
nal!
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern