American Audio Encore 1000 Betriebsanweisung PDF herunterladen (Seite 12)

GENERAL FUNCTIONS AND CONTROLS (Cont.) MIXER

B. MIXER CONTROLS (FIGURE 4)

17. SOURCE SELECTOR SWITCH - These switches are used to select the input source assigned to

each channel. Each channel may only be assigned one input source at a time.

18. AUX INPUT - This Aux input is for the use of a Mp3 player. Input volume will be controlled by

the channel two fader.

19. CHANNEL GAIN CONTROL - This adjustment is used to adjust an audio source signal input gain

for a channel. Never use the gain control to adjust output volume. Setting the gain level properly will

ensure a clean output signal. To properly set the gain level controls:

1. Be sure the MASTER VOLUME CONTROL (28) is set to level 4.

2. Set the CHANNEL FADER (22) to level 8.

3. Begin playback on an audio source connected to the channel you are adjusting.

4. Use the Gain Control (19) to adjust an average output volume of +4 dB.

5. Repeat this step for all channels.

20. EQUALIZER - All of the channels include a three-band signal EQ. These controls are used to

increase or decrease the LOW’s, MID’s, and HI’s of the output signal.

TREBLE CONTROL - This knob is used to adjust the treble levels of a channel allowing for a

maximum treble gain of +12dB or maximum decrease of -30dB. Turning the knob in a counter-

clockwise direction will decrease the amount of treble applied to a channel signal, turning the

knob in a clockwise direction will increase the amount of treble applied to a channel signal.

MIDRANGE CONTROL - This knob is used to adjust the midrange levels of a channel allowing

Figure 4

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 32 33

Keine Kommentare

American Audio Encore 1000 Betriebsanweisung Seite 12