American Audio VMS2 Betriebsanweisung PDF herunterladen (Seite 10)

©American Audio® - www.americanaudio.us - VMS2™ Instruction Manual Page 10



 Use this button to set this deck to master and auto sync and the other deck's

tempo to master.

 These buttons are used to store three (3) cue points.

These buttons are used to activate a channels “CUE” mode. The CUE LED will

glow when a channels cue mode is activated. The Cue function sends a channels incoming signal to

the headphones. The cue level is adjusted by the 

 The MIDILOG cue button has a additional function. During power-on, hold this button down to toggle the

post EQ mode on and off. For more on this please refer to the Virtual DJ Setup near the end of this manual.

These buttons allow easy navigation of your music library on your soft-

ware.



This knob is used to control the master output level. To avoid dis-

torted output try to maintain an average output signal level no greater than +4dB. To avoid speaker

damage that may be caused by excessive volume, be sure this knob is always set to zero (completely

down) before turning the unit on.

This knob is used to adjusts the monitor volume output level. Turn the knob in a

clockwise direction to increase the monitor volume.



This adjustment is used to adjust the audio source signal input gain

for a channel. Never use the gain control to adjust a channels output volume. Setting the gain level

properly will ensure a clean output signal. An improper gain level adjustment will send a distorted

signal throughout the entire audio line which may damage speakers and amplifiers. To properly set a

channels gain level control:

1. Be sure the is set to level 4.

2. Set the  to level 8.

3. Begin playback on an audio source connected to the channel you are adjusting.

4. Use the Gain Control to adjust an average output volume of +4 dB.

5. Repeat this step for all channels

 This knob is used to adjust the treble levels of a channel allowing

for a maximum treble gain of +6dB or maximum decrease of -100dB. Turning the knob in a counter-

clockwise direction will decrease the amount of treble applied to a channel signal, turning the knob in

a clockwise direction will increase the amount of treble applied to a channel signal.

 This knob is used to adjust the midrange levels of a channel

allowing for a maximum midrange gain of +6dB or maximum decrease of -100dB. Turning the knob

in a counter-clockwise direction will decrease the amount of midrange applied to a channel signal,

turning the knob in a clockwise direction will increase the amount of midrange applied to a channel

signal.

   This knob is used to adjust the low frequency levels of a channel

allowing for a maximum bass gain of +6dB or maximum signal decrease of -100dB. Turning the knob

in a counter-clockwise direction will decrease the amount of bass applied to a channel signal, turning

the knob in a clockwise direction will increase the amount of bass applied to a channel signal.



GENERAL FUNCTIONS AND CONTROLS (Cont.)

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 25 26

Kommentare zu diesen Handbüchern

Keine Kommentare

American Audio VMS2 Betriebsanweisung Seite 10

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für DJ-Controller American Audio VMS2