American Audio POWER DRIVE 22 Bedienungsanleitung PDF herunterladen (Seite 48)

©American Audio® - www.americanaudio.eu VMS4.1™ User Manual Page 48

20. CROSSFADER REPLACEMENT

The crossfader is “Hot Swappable” which means it may be replaced at any time, even when power is

applied. American Audio VMS4.1™ crossfader (part# Z-FF-8). If you wish to upgrade to an Innofader,

please order the Innofader model which comes with the VMS4.1™ plate cover to protect the Innofader

from damage during handling of the VMS4.1™. If you upgrade to the Innofader, please make sure the

power is off before upgrading to limit the chance of damage to the Innofader and/or VMS4.1™ during

installation. Replacing with any other model fader may seriously damage your mixer. Please, always

use insulated tools.

20.1 REPLACING HOW-TO

1. Disconnect the mixers main power supply

2. Using a Phillips screw driver, unscrew the two outside screws on each side that hold the cross fader assembly in place.

3. Gently remove the crossfader assembly from its seated position. You may need to wiggle the crossfader slightly to remove it.

4. After removing the crossfader assembly, disconnect the ribbon cable that attaches the cross fader to the PC board. Grasp the crossfader by

its base and pull the ribbon cable by its connector not the actual cables. The connector is designed to only fit one way, so don’t worry about

the connectors’ orientation.

5. Unscrew the two inner screws that connect the crossfader to the crossfader plate.

6. Connect the new crossfader to the ribbon cable and replace in reverse order.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 54 55

Keine Kommentare

American Audio POWER DRIVE 22 Bedienungsanleitung Seite 48