American Audio POWER DRIVE 22 Bedienungsanleitung PDF herunterladen (Seite 21)

©American Audio® - www.americanaudio.eu VMS2™ User Manual Page 21

Note: The MIDILOG Cue button has an additional function. During power-on, hold this button

down to toggle the Post EQ Mode on and off. For more on this, please refer to the Virtual DJ

Setup described in chapter 11 (Software and ASIO Driver Installation).

(4) Navigation Buttons – These buttons allow easy navigation of your music library on your

software.

(5) Master Volume and Booth Controls

Master Volume Control – This knob is used to control the master output level. To avoid

distorted output, try to maintain an average output signal level no greater than +4dB.

To avoid speaker damage that may be caused by excessive volume, be sure this knob is

always set to zero (completely down) before turning the unit on.

Booth Level – This knob is used to adjust the monitor volume output level. Turn the

knob in a clockwise direction to increase the monitor volume.

(6) MIDILOG Mixer Section

Channel Gain Control – This adjustment is used to adjust the audio source signal input gain

for a channel. Never use the gain control to adjust a channels output volume. Setting the

gain level properly will ensure a clean output signal. An improper gain level adjustment will

send a distorted signal throughout the entire audio line which may damage speakers and

amplifiers. To properly set a channels gain level control:

1. Be sure the Master Volume Control is set to level 4.

2. Set the Channel Fader to level 8.

3. Begin playback on an audio source connected to the channel you are adjusting.

4. Use the Gain Control to adjust an average output volume of +4 dB.

5. Repeat this step for all channels

Channel Treble Control – This knob is used to adjust the treble levels of a channel allowing

for a maximum treble gain of +6dB or maximum decrease of -100dB. Turning the knob in a

counter-clockwise direction will decrease the amount of treble applied to a channel signal,

turning the knob in a clockwise direction will increase the amount of treble applied to a

channel signal.

Channel Midrange Control – This knob is used to adjust the midrange levels of a channel

allowing for a maximum midrange gain of +6dB or maximum decrease of -100dB. Turning

the knob in a counter-clockwise direction will decrease the amount of midrange applied to a

channel signal, turning the knob in a clockwise direction will increase the amount of

midrange applied to a channel signal.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 39 40

Keine Kommentare

American Audio POWER DRIVE 22 Bedienungsanleitung Seite 21