American Audio HTD 4.5 Bedienerhandbuch PDF herunterladen (Seite 13)

5 & 6. Pitch Select Button - This button is used to change the pitch value. The

pitch percentage can be changed between 10%,

20% and 50%. 10% will allow the least amount of

pitch manipulation and 50% will allow the most

amount of pitch manipulation. Pressing the button's

will toggle between the two pitch modes. An LED will

indicate which pitch percentage mode is activated.

Note, the Quartz Lock (4) function must be turned off

in order for the pitch function to operate.

Special Note: As stated above the turntable also has a pitch percentage value of 50%. To activate the

50% pitch value press and hold both the +/- 10%(6) and +/- 20%(5) pitch values until both the their

respective LED's turn on.

7. Reverse Rotation Selector Button - The turntable has the ability to play records in

reverse. Simply press the button at any time to acti-

vate this function. The function LED will glow when

activated. To deactivate the reverse function, press

the button again.

8. Stop Control Knob - By adjusting the brake control knob, you can control

the time the turntable takes to come to a complete

stop.

9. Start Control Knob - Using the Start Control Knob, you can adjust the

time it takes for the turntable to get up to full RPM.

10. Target Light - The target light is designed to light up the stylus

in a dark environment for proper stylus positioning.

NOTE: When storing the turntable remove the

target light.

11. 45-rpm Speed Selector Buttons - Engaging this button will rotate the platter at 45

RPMs. A function LED will glow when this function

is activated.

12. 33-rpm Speed Selector Button - Engaging this button will rotate the platter at 33

revolutions per a minute (RPMs). A function LED will

glow when this function is activated.

Special Note: The platter has the ability to rotate at 78 RPMs. This is an outdated function that is

rarely used. To activate the 78 -RPM function press and hold both the 33 (12) and 45 (11) RPM selec

-

tors until both the their respective LED turn on.

13. START/STOP Button - This over sized push button controls platter

motion. When the unit is turned on the platter will not

automatically begin to spin. Pressing the button

once will engage the high torque motor and spin the

platter, pressing this again will stop the platter.

CONTROLS AND FUNCTIONS

American Audio HTD 4.5 Bedienerhandbuch Seite 13