American Audio POWER DRIVE 22 Bedienungsanleitung PDF herunterladen (Seite 35)

©American Audio® - www.americanaudio.eu VMS2™ User Manual Page 35

20. CROSSFADER REPLACEMENT

The crossfader is “Hot Swappable” which

means it may be replaced at any time, even

when power is applied.

Replace with American Audio VMS2™

crossfader (part# Z-FF-8).

If you wish to upgrade to an Innofader, please

order the Innofader model which comes with

the VMS2™ plate cover to protect the

Innofader from damage during handling of the

VMS2™. If you upgrade to the Innofader,

please make sure the power is off before

upgrading to limit the chance of damage to

the Innofader and/or VMS2™ during

installation.

Replacing with any other model fader may seriously damage your mixer.

20.1 REPLACING THE CROSSFADER

1. Disconnect the mixers main power supply.

2. Using a Phillips screw driver, unscrew the two outside screws on each side that hold the

cross fader assembly in place.

3. Gently remove the crossfader assembly from its seated position. You may need to

wiggle the crossfader slightly to remove it.

4. After removing the crossfader assembly, disconnect the ribbon cable that attaches the

cross fader to the PC board. Grasp the crossfader by its base and pull the ribbon cable

by its connector not the actual cables. The connector is designed to only fit one way, so

don’t worry about the connector’s orientation.

5. Unscrew the two inner screws that connect the crossfader to the crossfader plate.

6. Connect the new crossfader to the ribbon cable and replace in reverse order.

Note: For Innofader installation instructions please visit:

http://innofader.com/mixers.php?id=75

1 2 ... 30 31 32 33 34 35 36 37 38 39 40

Keine Kommentare

American Audio POWER DRIVE 22 Bedienungsanleitung Seite 35